2-38 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Measure the length [A] indicated in the figure.
Rear Master Cylinder Push Rod Length
68.5 ±1 mm (2.70 ±0.04 in.)
If it is not within the standard, adjust the push rod in the
master cylinder as follows.
Usually it is not necessary to adjust the pedal position,
but always adjust it when the master cylinder is disas-
sembled or pedal position is incorrect.
Loosen the push rod locknut [A].
Turn the adjusting bolt [B] to obtain the specified length.
Tighten the locknut.
Torque - Rear Master Cylinder Push Rod Locknut: 17 N·m
(1.7 kgf·m, 13 ft·lb)