Periodic Maintenance Procedures
Remove the silencer wool [A] and discard it.
Using a high flash-point solvent, clean off any oil or dirt
that may be on the liquid gasket coating area. Dry them
with a clean cloth.
Apply liquid gasket to the mating surface [A].
Sealant - Liquid Gasket, TB1215: 92104-1065
Replace the silencer wool with a new one and install it.
Install the muffler cover [A].
Apply a non-permanent locking agent to the muffler cover
bolts [B], and tighten them.
Torque - Muffler Cover Bolts: 10 N·m (1.0 kgf·m, 89 in·lb)
Torque - Muffler Mounting Bolt [C]: 21 N·m (2.1 kgf·m, 15
Right Side Cover (see Side Cover Installation in the
Clutch Operation Inspection
Clutch Lever (Clutch Cable) Free Play Inspection
Slide the clutch cable adjuster cover [A] out of place.
Check that the clutch cable upper end [B] is fully seated
in the adjusting bolt [C].
Install the adjuster cover to original position.
PERIODIC MAINTENANCE 2-27