Fuel Tank (see Fuel Tank Removal in the Fuel System
Open the clamps [A], and free the leads.
Slide the dust cover [B].
Disconnect the regulator/rectifier lead connector [C].
Regulator/Rectifier Bracket Bolts [A]
Regulator/Rectifier Bolts [A] and Nuts
Replace the regulator/rectifier nuts [A] with new ones.
Regulator/Rectifier Bolts [F]
Torque - Regulator/Rectifier Nuts: 8.0 N·m (0.82 kgf·m, 71
Regulator/Rectifier Bracket Bolt: 8.0 N·m (0.82
kgf·m, 71 in·lb)
Run the regulator/rectifier lead according to the Cable,
Wire, and Hose Routing section in the Appendix chapter.
Connect the regulator/rectifier lead connector.
Install the fuel tank (see Fuel Tank Installation in the Fuel
System (DFI) chapter).
Regulator/Rectifier Output Voltage Inspection
Be sure the prepared battery is fully charged.
ELECTRICAL SYSTEM 16-15