16-10 ELECTRICAL SYSTEM
Magneto Cover Removal
Drain the engine oil (see Engine Oil Change in the Peri-
odic Maintenance chapter).
Shift Pedal (see Shift Pedal Removal in the Crank-
Disconnect the magneto lead connector [A] from the main
Open the clamp [B] and then free the leads [C].
Magneto Cover Bolts [A]
Magneto Cover [B]
Magneto Cover Installation
Replace the gasket [A] with a new one and install it.
Be sure to install the dowel pins [B].
Using a high flash-point solvent, clean off any oil or dirt
that may be on the silicone sealant coating area. Dry
them with a clean cloth.
Apply liquid gasket to the area [A] to the magneto lead
Sealant - Liquid Gasket, TB1211F: 92104-0004
Magneto Cover [A]
Magneto Cover Bolts [C]
Torque - Magneto Cover Bolts: 10 N·m (1.0 kgf·m, 89 in·lb)
Run the loads and hose according to the Cable, Wire, and
Hose Routing section in the Appendix chapter.
Connect the magneto lead connector.
Install the removed parts (see appropriate chapters).
Remove the magneto cover (see Magneto Cover Re-