Handlebar Position Adjustment
The handlebar position can be adjusted in four positions
back and forth.
Front Holes [A]
Rear Holes [B]
Handlebar Holders [C]
To suit various riding positions, the handlebar holder po-
sition can be changed and the handlebar can be adjusted
by turning the handlebar holders around (180°).
Remove the handlebar pad.
Remove the handlebar clamp bolts [A], handlebar clamps
[B] and handlebar [C].
Check the handlebar for damage or cracks.
If the handlebar is damage or cracks, replace it with a new
Handlebar Holder Nuts [A]
Flat Washers [B]
Round Washers [C]
Handlebar Holders [D]
Select the handlebar position and install the upper and
lower dampers [A] into the hole [B] of the steering stem
head [C] so that the flat surface [D] of dampers fit the flat
surface [E] of the steering stem head hole.
Install the round washer [A] and handlebar holder [B] in
the suitable direction.
Install the round washer so that the round part fits on the