Apply adhesive cement to the innermost area of the left
handlebar grip and all-around inner surface of the left han-
dlebar grip hole entrance and also apply it to the roulette
area on the handlebars.
Install the left handlebar grip [A] as shown.
When installing the left handlebar grip, rotate the grip
more than once first, and then remove and install the grip
alternately more than three times to spread adhesive ce-
ment. Make sure that adhesive cement has been spread
After installation, hold the left handlebar grip area at more
than three points to make the left handlebar grip stick to
Install the clutch lever holder assembly [A] as shown.
25 ∼ 35° [B]
Horizontal Line of Frame [C]
148 mm (5.83 in.) [D]
Tighten the upper clamp bolt first, and then the lower
clamp bolt. There will be a gap at the lower part of the
clamp after tightening.
Torque - Clutch Lever Clamp Bolts: 4.0 N·m (0.41 kgf·m, 35
Install the launch control mode button [A] as shown.
Clutch Lever Holder Assembly [B]
5 ∼ 10 mm (0.2 ∼ 0.4 in.) [C]
Position the launch control mode button so that its upper
surface is paralleled with the horizontal line of frame [D].
Torque - Launch Control Mode Button Clamp Screw: 1.2
N·m (0.12 kgf·m, 11 in·lb)
Install the engine stop switch [E].
3 ∼ 8 mm (0.12 ∼ 0.31 in.) [F]
Align the engine stop switch with the clutch lever line [G].
Torque - Engine Stop Switch Clamp Screw: 1.2 N·m (0.12
kgf·m, 11 in·lb)
Run the launch control mode button lead and engine stop
switch lead correctly (see Cable, Wire, and Hose Routing
section in the Appendix chapter).