Tie-Rod, Rocker Arm
Tie-Rod and Rocker Arm Bearing Installation
Replace the needle bearings and grease seals with new
Install the needle bearings [A] as shown.
Flush Surface [B]
4 ±0.4 mm (0.16 ±0.016 in.) [C]
Install the bearings so that the marked side faces out.
Special Tool - Bearing Driver Set: 57001-1129
Install the grease seals.
Install the grease seals [D] so that the deep groove side
[E] faces inward.
Install the grease seals [F] so that the groove side [G]
Apply plenty of grease to the needle bearings and grease
Install the sleeves [H] and collars [I].
Front Side [J]
Right Side [K]
Left Side [L]
Rear Shock absorber [M]
Rocker Arm [O]