Tie-Rod, Rocker Arm
Rear Tie-Rod Mounting Bolt and Nut [A]
Rear Shock Absorber Mounting Bolt and Nut (Lower) [B]
Rocker Arm Pivot Bolt and Nut [C]
Rocker Arm [D]
When pulling out the mounting bolts, lift the rear
wheel slightly. Forcing or tapping on bolt could
damage the bolt, sleeve, and bearing.
Rocker Arm Installation
Replace the following parts with new ones.
Rear Shock Absorber Nut (Lower)
Rocker Arm Pivot Nut
Tie-Rod Mounting Nut
Apply plenty of grease to the needle bearings and grease
Check that collars are in place on the rocker arm.
Install the rocker arm.
Torque - Rear Shock Absorber Nut (Lower): 35 N·m (3.6
kgf·m, 26 ft·lb)
Rocker Arm Pivot Nut: 60 N·m (6.1 kgf·m, 44 ft·lb)
Tie-Rod Mounting Nut: 60 N·m (6.1 kgf·m, 44 ft·lb)
Tie-Rod and Rocker Arm Bearing Removal
Tie-Rod (see Tie-Rod Removal)
Rocker Arm (see Rocker Arm Removal)
Grease Seals [C]
Remove the needle bearing [D], using the bearing driver
Special Tool - Bearing Driver Set: 57001-1129
Remove the needle bearings [E], using the oil seal & bear-
Special Tool - Oil Seal & Bearing Remover: 57001-1058