Swingarm Bearing Installation
Replace the needle bearings and grease seals with new
Install the needle bearing [A] and grease seal [B] as
Flush Surface [C]
1.5 mm (0.059 in.) [D]
Install the needle bearings so that the manufacture's
marks face out.
Install the grease seals so that the deep groove side of
the rip to the needle bearings.
Special Tool - Bearing Driver Set: 57001-1129
Install the needle bearing [E] and grease seal [F].
Apply plenty of grease to the needle bearings and grease
Install the sleeve [G] and collar [H].
The installation procedure is the same as the counter
Drive Chain Guide, Guide Roller, Chain Slipper
Visually inspect the drive chain guide [A] and replace it if
excessively worn or damaged.
Visually inspect the upper and lower chain guide rollers
[A] and replace them if excessively worn or damaged.
Visually inspect the chain slipper [A] on the swingarm and
replace it if excessively worn or damaged.