Front Master Cylinder Removal
Remove the banjo bolt [A] to disconnect the brake hose
upper end [B] from the master cylinder [C].
When removing the brake hose, temporarily secure the
end of the brake hose to some high place to keep fluid
loss to a minimum.
Remove the clamp bolts [A], and take off the master cylin-
der [B] as an assembly with the brake lever.
Brake fluid quickly damages painted or plastic
surfaces; any spilled fluid should be completely
washed up immediately.
Front Master Cylinder Installation
Install the master cylinder [A] position as shown.
165 mm (6.50 in.) [B]
Horizontal Line of Frame [C]
Horizontal Line of Cap Surface [E]
The master cylinder clamp must be installed with the ar-
row mark [A] upward.
Tighten the upper clamp bolt [B] first, and then the lower
clamp bolt [C].
There will be a gap at the lower mating surface of the
clamp after tightening.
Torque - Front Master Cylinder Clamp Bolts: 9.0 N·m (0.92
kgf·m, 80 in·lb)