Magneto Cover (see Magneto Cover Removal in the
Electrical System chapter)
Hold the flywheel [A] steady with the rotor holder [B], and
loosen the balancer weight mounting nut [C].
Special Tools - Grip [D]: 57001-1591
Rotor Holder: 57001-1730
Right Engine Cover (see Right Engine Cover Removal
in the Clutch chapter)
Flywheel (see Flywheel Removal in the Electrical Sys-
Balancer Weight Mounting Nut [A]
Balancer Weight [B]
Balancer Gear [C]
Pull out the balancer shaft [A] from the right crankcase
Insert the balancer shaft from the right crankcase half.
Install the balancer gear so that the stepped portion [A] on
the balancer shaft is aligned with the short length tooth [B]
on the balancer gear.