Transmission Shaft Assembly
Apply engine oil liberally to the transmission shaft, gears
Replace any circlips that were removed with new ones.
Always install the circlips [A] so that the opening [B] is
aligned with a spline groove [C], and install toothed wash-
ers. To install a circlip without damage, first fit the circlip
onto the shaft expanding it just enough to install it, and
then use a suitable gear to push the circlip into place.
Special Tool - Outside Circlip Pliers: 57001-144
When install the bushing (for 4th) [A] to the drive shaft,
align the oil passage holes [B] each other.
The drive shaft gears can be identified by size; the small-
est diameter gear is 1st gear, and the largest is 5th. Be
sure that all parts are put back in the correct sequence,
facing the proper direction, and that all circlips and the
washers are properly in place.
The output shaft gears can be identified by size; the
largest diameter gear is 1st gear, and the smallest is
5th. Be sure that all parts are put back in the correct
sequence, facing the proper direction, and that the circlip
and collar are properly in place.