Shift Rods [A] (see Transmission Shaft Removal)
Shift Forks [B] (see Transmission Shaft Removal)
Shift Drum [C] (see Transmission Shaft Removal)
Transmission Shafts [D] (see Transmission Shaft Re-
Crankshaft [E] (see Crankshaft Removal)
Transmission Oil Nozzle [F]
Remove the oil screen (feed) [A].
Do not remove the bearings and the oil seals unless
it is necessary.
Removal may damage them.
Right and left crankcase halves are machined at the
factory in the assembled state, so if replaced, they
must be replaced as a set.
Remove the old gasket from the mating surfaces of the
crankcase halves and clean them off with a high flash
Using compressed air, blow out the oil passages in the
Gasoline and low flash-point solvents can be
flammable and/or explosive and cause severe
burns. Clean the engine parts in a well-ventilated
area, and take care that there is no spark or flame
anywhere near the working areas.
gasoline or low flash-point solvents to clean parts.
Do not use