Install the friction plates and steel plates, starting with a
friction plate and alternating them. Finishing with a friction
There are 2 different friction plates installed in the clutch
When servicing the clutch, use a permanent marker to
identify each friction plate before removing them so that
they can be reinstalled in the correct positions.
If new dry steel plates and friction plates are in-
stalled, apply engine oil to the surfaces of each
plate to avoid clutch plate seizure.
Apply molybdenum disulfide grease to the push rod end
[A] sliding portion [B] of the push rod holder.
Do not close the oil passage hole on the push rod holder
with the molybdenum disulfide grease.
Install the push rod and push rod holder.
Apply molybdenum disulfide grease to the needle bearing
[C] and washer [D], and install them.