Clutch Lever and Cable
Loosen the adjusting nut fully and align the slit [A] of the
adjusting nut to the slit [B] of the clutch lever.
Free the clutch cable upper end from the clutch lever.
Free the clutch cable lower end [A] from the clutch release
Do not remove the clutch release shaft unless it is
absolutely necessary. If removed, release shaft oil
seal must be replaced with a new one.
Open the clamps [A].
Pull the clutch cable out of the frame.
Clutch Cable Installation
When installing the adjusting nut, apply grease to the lips
[A] of adjusting nut.
Install the clutch cable with the threads width as shown.
0 mm (0 in.) [A]
Run the clutch cable correctly (see Cable, Wire, and Hose
Routing section in the Appendix chapter).
Adjust the clutch cable (see Clutch Lever Free Play Ad-
justment in the Periodic Maintenance chapter).
Install the removed parts (see appropriate chapters).