5-24 ENGINE TOP END
Take care not to damage the chain guides [A].
Do not touch the radiator core. This could damage
the radiator fins, resulting in loss of cooling effi-
Remove the cylinder head gasket [B].
Cylinder Head Installation
Fit the projections [A] of the front camshaft chain guide in
the grooves [B] of the cylinder.
Insert the guide end [C] into the recess [D] of the
Replace the cylinder head gasket with a new one.
Dowel Pins [A]
Cylinder Head Gasket [B]
Install the cylinder head while inserting the throttle body
assy to the throttle body assy holder.
The camshaft caps are machined with the cylinder
head; therefore, if a new cylinder head is installed, use
the caps that are supplied with the new head.
Replace the cylinder head bolt (M10) washers with new
These washers could leak oil if reused.
Apply molybdenum disulfide oil solution to the following
Cylinder Head Bolt (M10) Washers (Both Sides) [A]
Cylinder Head Bolt (M10) Threads [B]
Tighten the cylinder head bolts (M10) in the numbered
sequence [1 ∼ 4].
Torque - Cylinder Head Bolts (M10): 59 N·m (6.0 kgf·m, 44
L = 140 mm (5.51 in.) [1, 3]
L = 127 mm (5.00 in.) [2, 4]