Logging In Through The Osn|M Internal Service Interface Using Ssh - 3Com 5500G Getting Started Manual

Logging In Through
the OSN|M Internal
Service Interface
Using SSH
n
Configuration
Example

Logging In Through the OSN|M Internal Service Interface Using SSH 21

After you install the OSN|M into the Switch 5500G's expansion module
slot, the OSN|M exchanges information with the switch through its two
internal service interfaces, which display as Eth0 and Eth1 in the Linux
system.
The Switch 5500G provides two internal ports GigabitEthernet 1/1/1 and
GigabitEthernet 1/1/2 to connect with Eth0 and Eth1. Eth1 can be used
as an external interface when the OSN|M serves as the SSH server. The
default IP address of Eth1 is 10.10.10.6/24.
As shown in Figure 4, you can connect an SSH client with the OSN|M
resident switch or another switch in the fabric containing the OSN|M
resident switch, and then use SSH to log into the OSN|M's Linux system
through the OSN|M's Eth1 interface.
A Switch 5500G Ethernet switch provides two internal ports,
GigabitEthernet 1/1/1 and GigabitEthernet 1/1/2, to connect to the
OSN|M. Do not perform any configuration except to disable the Spanning
Tree Protocol (STP) on GigabitEthernet 1/1/1, and do not perform any
configuration on GigabitEthernet 1/1/2 except to allow a VLAN to pass.
Network diagram
Figure 4 Logging in through the OSN|M's internal service interface Eth1 using
SSH
between the OSN|M and the switch
SSH client
GE 1/0 /2 on the switch
10 . 10 . 10 . 1 / 24
Internal connection
Eth 1
10 . 10 . 10 . 6 / 24
GE 1 / 1 / 2
Switch with OSN|M