Key Facilities Programmable By System Management; Progammable Key Facilities - Alcatel 4035 User Manual

Omnipcx enterprise attendant set
Hide thumbs Also See for 4035:
Table of Contents

Advertisement

Chapter
4
4.1

Progammable key facilities

Directory number supervision
By this programming, pressing the key activates ringing directly on the user set. The pictogram
is off if the user set is idle position and free.
The pictogram :
«
» indicates that the user is busy,
«
«
«
A set can be supervised by one or more attendants.
Abbreviated number
An often used abbreviated number to the exterior can be programmed directly on a key.
Pressing the key activates the o/g call as if it had been dialled on the keypad.
Individual routing
This function allows the attendant to route and supervise an external «incoming» call without
this call being placed in the common waiting queue and re distributed.
When a call is being routed, the «
end of the routing timer, the «
wait (individual routing does not increment the «Normal wait - Urgent wait » counters).
As long as the set has not answered, the attendant can retrieve the call by pressing the routing
key ; the flashing «
Note: In the case of a local call or o/g call, this key can be activated. It is used to transfer the call.
Network / network transfer
This function is used to inter-connect 2 external trunks via the installation, with the possibility
of releasing the connection.
After an incoming call, the attendant initiates an outgoing call to a correspondent and enters
conversation.
Pressing the key connects the 2 trunks and the supervision is activated: the «
pictogram is on steady. Pressing the key again results in attendant break-in (intrusion) with
the break-in tone: the central segment of the «
again results in exit from break-in and restarts the supervision: the «
steady again.
Once the connection is released, the «
Note: This function can only be activated in the case of two external calls.
3EU19875ENAA - Ed. 01 - September 2002 - Alcatel 4035 Attendant set
Key facilities programmable
by system management
» indicates that the user is in call mode to the attendant set,
» indicates that the user is on hold. It flashes when the timer has expired,
» indicates that the user has left a call-back request.
» pictogram goes out.
» pictogram is lit. If the set does not reply before the
» pictogram will flash to indicate the change to «urgent »
» pictogram flashes. Pressing the key
» pictogram goes out.
»
» pictogram is on
4-1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents