Honeywell Satellite XT 9602-0200 4-20 mA Operation Manual page 45

C O N F I G U R A T I O N
N EW S E N S OR T Y P E
s e l e c t : 8
N E W S E N S O R T Y P E
R EMO V E S E N S OR
< s e t > w h e n
N E W S E N S O R T Y P E
N EW S E N S OR
p l e a s e i n s e r t
N E W S E N S O R T Y P E
L O A D N EW D A T A ?
< s e t > t o
N E W S E N S O R T Y P E
L O A D I NG D A T A !
p l e a s e w a i t
C O N F I G U R A T I O N
G A S N AME
s e l e c t : 9
G A S N A M E
A s H 3
p l e a s e e n t e r
Satellite XT 4-20 mA Versions
Allows the user to configure the instrument for a new
sensor type with a part number, which is different from
the one presently used.
o f 1 3
See Section 8 for Sensor Information.
Actuate the <set> key to enter and follow the dialogue
displayed.
Remove the sensor presently installed and actuate the
<set> key to proceed.
r e a d y
Insert the new sensor and actuate the <set> key to
proceed.
!
If you want the data of the new sensor to be loaded,
confirm this by pressing the <set> key..
c o n f i r m
The new data are now loaded from the sensor into the
instrument's internal memory.
!
Allows the user to enter a different gas name than the
one stored in the sensor's data memory. Up to 7
alpha-numeric characters can be entered.
o f 1 3
Use the <set> key to enter. The instrument will display
the actual gas name.
Use the cursor keys <left> or <right> to reach the de-
sired position. Use the cursor keys <up> and <down>
to select the characters you wish to enter. When the
new gas name has been entered completely, actuate
!
the <set> key to confirm or <esc> to exit.
Configuration - Section 6
New Sensor Type
Remove Sensor
New Sensor
Load New Data ?
Loading Data !
Gas Name
<Actual Gas Name>
6-11