Radio Shack 15-1867 Owner's Manual

0KIJV".KIJV"1"+PFQQT"68"#PVGPPC
15-1867
# #
"+/2146#06"
If an icon appears at the end of a
paragraph, go to the box on that
page with the corresponding icon
for pertinent information.
Rý
#
— Warning — Important
° ° ° °
. . . .
— Caution — Hint
±
— Note
. .
"%#76+10"
If you do not plan to use the
antenna for several months,
remove the batteries. Batteries can
leak chemicals that can destroy
electronic parts.
± ±
"016'" "
• The power from the batteries or
adapter is only for the night light
LED. The antenna will work
without the power for the LED.
• The antenna has a light sensor
circuit that automatically lights if
you are using an adapter or
have batteries installed. If you
press LIGHT while in a dark
room, the light turns on. When
the surroundings are bright, the
light will not turn on when you
press LIGHT.
OWNER'S MANUAL — Please read before using this equipment.
Thank you for purchasing the RadioShack Night Light/
Indoor TV Antenna. It can receive both VHF and UHF
channels, and consists of loop and telescoping antenna
elements. A 6-foot coaxial cable with a gold plated male F-
connector is attached to the antenna for TV connection.
VHF Telescope Rod Antennas — Swivel up
to 180 degrees for the best VHF reception.
UHF Turntable Knob
— Adjust knobs to
receive UHF stations in
most metropolitan
areas.
TUNING — Adjust to 12
different settings to fine tune
VHF channels.
219'4+0)"6*'"#06'00#
Your antenna uses an optional 4.5V DC, 100mA adapter or
three size C batteries (not supplied, available at your local
RadioShack store) for illuminating the night light indicator.
After connecting to power, press
.# .# .# .#
off while in darkness.
9 " "#
+6* #0 &#26'4
Plug a 4.5V DC, 100mA adapter into the antenna's
jack. Plug the adapter into an AC outlet.
9 "$
+6* #66'4+'5
1. Use a screwdriver to loosen the screw from the battery
compartment cover, and remove the cover.
©
2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
UHF Turntable
Knob
LIGHT — After connecting to
power, press it to turn the night
light on or off when in darkness.
to turn the light on or
LIGHT
±
DC 4.5V