How To Replace The Defective Blu-Ray Loader - Philips HTS7202/12 Service Manual

Software upgrade will take 5 minutes
Do not switch off!
Package version: 000025.0
Software BE Completed
Software FE Completed
Software MCU1: Not started
Software Dock: 2%
Software MCU3: Not started
Software upgrade will take 5 minutes
Do not switch off!
Package version: 000025.0
Software BE Completed
Software FE Completed
Software MCU1: 1%
Software Dock: Failed
Software MCU3:
f) The set will shut down automatically when the software upgrade
is completed.

6)How to replace the defective Blu-ray Loader

a) Remove the defective Blu-ray Loader.
b) Remove the shield cover at the top of Blu-ray Loader as shown
below.
2 - 2
c) Assembly Blu-ray Loader to "J800","J900","J905" on the top of
BD Board as shown below.
d) Remove soldered joint on the ESD protection points.
The ESD protection points
on the top of board
The ESD protection points
on the top of board
Top side view of OPU Bottom side view of OPU
Note: The 2 ESD protection points on any one side must be
soldered if
o the Blu-ray Loader is OK and needs to be disconnected
from connector J800, J900 and J905 of the BD Board.
o the defective Blu-ray Loader is needed to be send back to
supplier for failure analysis and to support backcharging evidence.
CAUTION!
This information is confi dential and may not be
distributed.Only a qualifi ed service person should
reprogram the Region Code.
2 - 2