Radio Shack 61-2234 User Manual

Electronic Equipment Surge Protector
• Detects and protects against a power surge of up to 6,000 Volts and 39,500 Amps in 1 nanosecond (1 billionth of a
second).
• Protects connected equipment from surges of up to 550 Joules.
• Lets you plug up to six devices into your surge protector.
• Has coaxial connectors for protection against surges through cable TV or antenna cables.
WARNING:
To reduce the risk of fire or shock hazard, do not ex-
pose this product to rain or moisture.
CAUTION
RISK OF ELECTRIC SHOCK. DO NOT
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER OR BACK. NO USER-SERVICE-
ABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
PERSONNEL.
This symbol is intended to alert you to the pres-
ence of uninsulated dangerous voltage within the
product's enclosure that might be of sufficient
magnitude to constitute a risk of electric shock.
Do not open the product's case.
This symbol is intended to inform you that impor-
tant operating and maintenance instructions are
!
included in the literature accompanying this
product.
Cautions:
• This surge protector is not a lightning arrestor and
might not protect against lightning-induced voltage
surges.
• Be sure the combined wattage of all connected
devices does not exceed 1,800 watts.
• Use the surge protector only with a three-prong stan-
dard AC outlet or a grounded two-to-three prong
adapter. The surge protector cannot provide protec-
tion without a grounded AC source.
• The equipment you plug into the surge protector must
have the same voltage and frequency ratings as in
"Specifications."
!
OPEN.
© 1999 Tandy Corporation.
RadioShack is a registered trademark used by Tandy Corporation.
Protect your valuable components from damage caused
by sudden increases in electrical power inside or outside
your home, caused by air conditioners, refrigerators, and
other large appliances switching on and off. Your surge
protector absorbs these spikes and surges . It also im-
proves the performance of connected components by fil-
tering electromagnetic and radio frequency interference.
Plug the surge protector's three-prong plug into a nearby
dual AC outlet. Then plug your equipment's AC plug into
one of the surge protector's six outlets.
When your surge protector's Protected When Lit light is
lit, your surge protector absorbs surges and spikes within
the limits of it specifications. If a strong surge or spike
damages connected equipment while the indicator is lit,
refer to the "RadioShack Limited Warranty and Connect-
ed Equipment Guarantee" for claim conditions and proce-
dures.
Important: A surge or spike beyond the specified limits
might overload the protection circuitry and render it inac-
tive. If this happens, the surge protector should absorb
enough of the surge to protect the connected equipment,
but it will not protect against future surges and spikes. If
this happens and the Protected When Lit light goes out,
replace the surge protector.
All Rights Reserved.
61-2234
Cat. No.