12-1738.fm Page 1 Friday, January 7, 2000 9:07 AM
6- x 9-Inch 2 Way Flush-Mount Speaker System
CHOOSING A LOCATION
For the best performance, install these
speakers on a solid, firm surface that
does not vibrate at high volume levels.
We recommend you mount the speak-
ers in the door panels or the rear
deck.
Note: Cardboard or fiber panels are
not good mounting surfaces.
(illus showing suggested
mounting area.)
As you are deciding on a location,
carefully inspect the area behind the
proposed mounting surface.
• There must be a clear unob-
structed area of at least 3 inches
(76.2 mm) behind the panel.
• If it is a door location, check to be
sure the window, window mecha-
nism, and window handle will
clear the speaker.
Note: Make sure the window
opens and closes properly.
RadioShack is a registered trademark used by Tandy Corporation.
INSTALLING THE
SPEAKERS
1. Use the supplied template to mark
the speaker opening and the
mounting-screw hole locations.
2. Cut out the marked speaker open-
ing in the mounting surface.
Note: Steel door panels and the
rear deck (behind the upholstery)
might already have large cut-out
areas for recessing the speaker.
3. Drill
holes.
Caution: Be careful not to drill
into anything behind the mounting
surface.
4. If necessary, route new speaker
wire from the autosound system to
the mounting area.
Cautions:
• Avoid routing speaker wires
near
edges, or where they will be
pinched or stepped on. You can
usually route them along the
channel beneath the vehicle's
door facings.
© 2000 Tandy Corporation.
All Rights Reserved.
12-1738
Cat. No.
the
four
mounting-screw
moving
parts,
sharp