Programming Motorola Analog, Digital, And Apco-25 Trunking Systems - Radio Shack PRO-96 Owner's Manual

P
ROGRAMMING
M A
OTOROLA NALOG
D ,
IGITAL AND
T S
RUNKING YSTEMS
1. Press and
PGM
or to select the desired
channel storage bank to
Ô
program.
2. Press to access the ID
TRUNK
list and set the correct
trunking bank type. If the bank
has never been programmed
with a trunking system, the
scanner will display
trunked! Press mode
3. Press until
MODE
appears in the display. This
sets the channel storage bank
for Motorola operation.
4. Press to return to the
PGM
channel storage bank.
5. Select a channel to begin
programming trunking system
frequencies. Use direct
channel entry or the
keys.
6. Enter the trunking frequency
and press
ENTER
necessary, press
change the receiving mode to
MO
(Motorola).
7. Repeat Steps 5 and 6 to enter
the other trunking system
control channel frequencies
for the system you wish to
monitor.
,
A -25
PCO
•
then
FUNC
•
•
Not
.
Motorola
•
•
or
. If
to
MODE
•
•
Ô Ô
NOTES
You can also press
FUNC, then TRUNK
to access the ID list
from manual mode.
When monitoring
Motorola trunked
radio systems, it is
only necessary to
program the trunking
control channel.
For APCO-25
trunking systems
using the 9600 bps
control channel,
program the system
using the steps
outlined above for
Motorola systems.
Your scanner will
automatically detect
the proper control
channel type.
Some systems rotate
the control channel
on a daily basis. For
best results, program
all known control
channel frequencies
into the trunking
channel storage
bank.
To program Motorola
UHF trunking
systems, see
"Programming
Motorola VHF and
UHF Trunking
Systems" on
Page 34.
To program Motorola
800 MHz "splinter"
systems, see
"Programming
Motorola 800 MHz
Splinter Systems" on
Page 36.
To program Motorola
Type I/IIi fleet maps,
see "Programming
Fleet Maps" on
Page 36.
33