Network Components - Mitsubishi Electric FR-A820-00046 Instruction Manual

Fr-a800 series
Hide thumbs Also See for FR-A820-00046:
Table of Contents

Advertisement

Installation and wiring
2.11.3

Network components

This section describes components comprising the CC-Link IE Field Network.
● Connection cable
For wiring, use the 1000BASE-T compliant Ethernet cables.
Ethernet cable
Category 5e or higher
(Double shielded/STP ) Straight cable
STP - Shielded Twisted Pair
● Recommended products (as of February 2015)
Model
SC-E5EW series
SC-E5EW cable is for in-enclosure and indoor uses. SC-E5EW-L cable is for outdoor use.
NOTES
For CC-Link IE Field Network wiring, use the recommended wiring components by CC-Link Partner
Association (CLPA).
Cables for CC-Link IE Controller Network cannot be used for CC-Link IE Field Network.
Depending on the cable connector shape, the cable may not be connected to the communication
connector.
● Hubs
Use hubs that meet the conditions listed below:
– Compliance with the IEEE802.3 (1000BASE-T)
– Support of the auto MDI/MDI-X function
– Support of the auto-negotiation function
– Switching hub (layer 2 switch) – a repeater hub is not available.
Operation is not guaranteed if the hubs do not meet these conditions.
Industrial switching hub
Type
NZ2EHG-T8
FR-A800
Wiring for use of the CC-Link IE Field Network (FR-A800-GF)
Connector
RJ-45
Manufacturer
Mitsubishi Electric System & Service Co.
Manufacturer
Mitsubishi Electric Corporation
Type
The following conditioning cables:
IEEE802.3 (1000BASE-T)
ANSI/TIA/EIA-568-B (Category 5e)
2 - 105

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents