Radio Shack PRO-2051 User Manual page 21

Beyond the Basics
2. Enter the channel number where you want to store
a frequency and press HOLD/RESUME to select the
channel.
3. Enter the frequency you want to store by using the
keypad and ./CLR.
4. Press E to store the frequency into the channel.
5. To store the next channel in sequence, press
Steps 3 and 4.
To clear a mistake while entering the frequency,
Notes Notes
repeatedly press ./CLR until the display is cleared.
If you enter an invalid frequency, an error tone
sounds and Error appears. To clear the error message
immediately, press ./CLR.
Your scanner automatically rounds the entered number
to the nearest valid frequency. For example, if you enter
151.473 (MHz), your scanner accepts it as 151.475.
When you enter a frequency into a channel, your scanner
automatically turns on the delay function and DLY
appears on the display. When delay is turned on, the
scanner automatically pauses scanning 2 seconds after
the end of a transmission before scanning proceeds to
the next channel. To turn delay off or on, press DELAY.
If you enter a frequency that has already been entered
elsewhere, the scanner sounds an error tone and
displays the channel that was duplicated. If you entered
the frequency by mistake, press ./CLR, then enter the
correct frequency. To enter the frequency anyway, press E
to accept.
21
and repeat
e