Scan Lists; Manually Storing Ids Into Scan Lists - Radio Shack PRO-2050 Owner's Manual

20-430.fm Page 31 Wednesday, August 4, 1999 1:29 PM

SCAN LISTS

When you program trunked frequen-
cies into a bank (see "Programming
Trunked Frequencies" on Page 26),
your scanner sets up 5 scan lists into
which you can store your favorite IDs.
Each list can contain up to 10 IDs, so
you can store a total of 50 IDs for each
trunk tracking bank (500 IDs if you use
all banks as trunking banks!).
Scan lists help you organize trunking
system users into categories. For ex-
ample, you might use List 1 for police
IDs, List 2 for fire department IDs, List
3 for emergency medical service IDs,
and so on. Once IDs are stored in
lists, you can scan them like you scan
conventional channels. You can pro-
gram IDs into scan lists manually, dur-
ing a search, or automatically.
Manually Storing IDs into
Scan Lists
1. Select the trunking bank you want
(see "Scanning a Trunked Bank"
on Page 27).
2. After the scanner begins trunk
tracking, press
list number appears at the top of
the display, and a bar shows the
channel activity.
. A scan
MANUAL
Scan List Number
3. Repeatedly press s or t to select
the scan list location (shown at the
top of the display) you want to
program.
4. Enter the Type II ID you want to
store, then press .
E
Or, to enter a Type I ID:
a. Use the number keys to enter
the block number and the fleet
number, then press
b. Enter the subfleet number, then
press .
E
Note: To clear a mistake while
entering an ID, press
start over at Step 4.
5. Repeatedly press
MANUAL
select the next scan list location
you want to program. Then repeat
Step 4 to enter another ID.
•
.
CLEAR , then
or s to
31