Radio Shack 49-1003 User Manual

Wireless Motion Detector
This wireless motion detector is for use with
your Wireless Security Kit (49-1000). Your
Wireless Security Kit includes one motion
detector. Purchase up to 29 additional (30
total) motion detectors to expand and protect
all 30 system zones. You can add additional
door/window sensors and additional motion
detectors, as long as the additional units do not
exceed 30 (number of zones in your system).
Refer to your 49-1000 user guide for more
information on adding motion detectors and
door/window sensors to your wireless system.
The motion detector senses movement up to
40 feet away, and should be mounted within
100 feet of the console to work properly.
motion detector
mounting screws (2)
machine screw (1)
mounting bracket
Please read this user's guide before
installing, setting up and using your new product
www.radioshack.com

installing batteries

49-1003
1. Remove
the battery
compartment
cover.
2. Insert 2 AA
alkaline
batteries.
3. Replace the cover.
4. After replacing the batteries, press
arm to arm your system. Walk past the
motion detector. If the system does not
trip, register the motion detector again.
Follow steps 1 thru 6 of "registering
your motion detector".
If the motion detector stops working properly, or
PROBLEM appears on your console display, replace
the motion detector's batteries.
• Dispose of old batteries promptly and properly.
• Do not burn or bury batteries.
• Use only fresh batteries of the required size and
recommended type.
• Do not mix old and new batteries, different types
of batteries, or batteries of different capacities.
what's included
motion detector
mounting screws (2)
Thank you for purchasing your Wireless
Motion Detector from RadioShack.

registering your motion detector

1. Hold down TEST on your motion detector for
3-4 seconds and then release it.
Note: If you need to register the motion

detector a second time, remove the batteries,
and then hold down TEST for 3-4 seconds to
pick up a random code.
2. Press menu start
system console. ENTER PIN (Personal
Identification Number) appears on the
display.
3. Use the console keypad to enter your four-
digit PIN. * appears on the display as each
digit is pressed. After you enter your PIN, 1.
INSTALL appears.
4. Press ok and 1. INSTALL / ZONE appears.
5. Press TEST on your motion detector. The
console chimes and ZONE 1 SET appears on
the console display to confirm registration.
6. Press clear to navigate backward through
mounting bracket
the console menu options. Press 1 to return
machine screw (1)
to the main display, or press 2 to stay in
install mode and register additional motion
detectors.
Refer to your Wireless Security Kit User Guide (49-
1000) for instructions on how to change your PIN.




or on your security