Radio Shack 20-125 User Manual

AM/FM/SW with Travel Alarm
Thank you for purchasing your AM/FM/SW with Travel Alarm
from RadioShack. You can store two clock times and up to 30
preset stations.
SW (shortwave) BAND
When listening to SW, press once or
more to fast tune SW frequencies.
DUAL TIME MEM/TIME
Press to toggle Press to enter radio preset
between the two mode/clock time setting
clock times. Hold for 5 mode. (see "presetting
seconds to view time radio stations" and
when radio is on. "setting the clock time").
Please read this user's guide before
installing, setting up and using your radio.
www.radioshack.com
20-125.indd 1
installing batteries
20-125
Slide to remove the battery compartment cover and insert three AA
alkaline batteries matching the polarity symbols (+ and -) marked inside.
To avoid losing memory and alarm settings, turn off the radio before
Note
replacing the batteries and replace the batteries within 30 seconds.
FM/AM/SW SNOOZE
Slide to select a Press to mute the alarm
band. for about 9 minutes.
ALARM
POWER
Press to enter
ON/OFF
alarm setting
mode (see Press to
"setting the turn on/off
the radio.
alarm").
Radio
LIGHT
Press and hold to turn
on the backlight.
DX/LOC SENS
(for FM and SW)
Select for best reception of
distant or local stations. Set
to LOC to receive strong local
signals, or set to DX to improve
reception of a weak station.
LOCK
Slide up to lock all the buttons.
appears.
HOUR + – Press or hold to tune
radio frequencies or adjust the
hour digit.
MIN - – – Press or hold to tune
radio frequencies or adjust the
minute digit.
ENTER – – See "direct entry to
stations".
TIMER – – See "setting the timer".
SLEEP
Press to select a preset period to
automatically turn off the radio (see
"setting the sleep timer").
what's included
•Always connect the AC adapter to the radio before you connect it to AC
User's Guide
power. When you finish, disconnect the adapter from AC power before you
disconnect it from the radio.
• The correct orientation for this power unit is in a vertical or floor mount
position.
Stand ANTENNA (for FM and SW)
Pull out and place radio FM: Fully extend the antenna,
on a level surface. and rotate for best reception.
SW: Position the antenna
vertically for best reception.
AM: This uses a built-in
ferrite rod antenna. Position
your radio for best reception.
VOL MAX-MIN
Turn to adjust the
volume.
HIGH/LOW TONE
Switch to HIGH for
normal sound and
to LOW to reduce
high frequencies.
*
Connect 3.5mm
headphones (not
supplied) for
private listening.
using AC power supply (DC 6V )
Connect one end of an optional AC adapter to DC 6V
your radio and the other end to an standard AC wall outlet.
CAUTION: You must use a power source that supplies DC 6V
and delivers at least 300 mA. Its center tip must be set to positive
!
and its plug must fit the radio's DC 6V jack. Using an
adapter that does not meet these specifications could damage the
radio or the adapter.
jack of
1/08/2007 11:16:16