VCM II Customer Flight Recorder Operator's Manual
To redisplay a parameter:
1. Select the Parameter Selection from right margin, as shown in Figure 12.0.
2. Select a parameter to highlight and redisplay that parameter.
The DTC screen is also available to view any DTCs that were present before or after the recording was
made. Any new DTC will have an asterisk next to it. Codes are listed under CMDTCs and Pending DTCs,
and the code descriptions appear when the DTC is highlighted. If DTCs appear on this tab, it is advised that
the technician run Selftest on the module or system to retrieve more information related to the DTCs such
as freeze frame, snap shot, etc.
- 21 -