Getting Ready
1.
Remove the four screws (two on each end)
from back board
2.
Attach side panels
. Secure side panels
board
using the screws you removed in
step 1.
IMPORTANT!
PX-870
• Make sure that the edge of back board that has
the line of screw holes is facing downwards.
C
B
• Attach the side panels so the side of the back board
where the joint connectors are inserted is facing
towards the back of the stand.
• If you have trouble inserting a screw into a joint
connector screw hole, use a screwdriver to adjust
the joint connector by rotating it.
EN-50
.
C
and
to back board
and
to the back
Screw holes
IMPORTANT!
Joint connectors
• When inserting a screw into a
joint connector, keep your
finger on the joint connector
hole on the back of back board
to make sure the joint
connector does not come out
of the hole.
B
3-1.
If you plan to locate the piano and stand
where it is not against a wall, you need to
extend the anti-tip brackets at the base of
side panels
screws (one on the outside of each side
panel) that hold the brackets, and then slide
the brackets as shown in the illustration. After
extending the anti-tip brackets, reinstall the
A
screws that secure them in place, but do not
tighten the screws fully at this time.
[Inside of side panels]
C
C
and
. Remove the two
A