Turning The Key Tone On And Off; Checking The Current Memory Settings; Setting The Frequency Step - Radio Shack HTX-200 Owner's Manual

TURNING THE KEY TONE ON AND OFF

The transceiver is preset to sound a beep each time you press a
key. To turn off the beep, press
To restore the key tone, press
Note: If the key tone feature is disabled, the power-on tone does
not sound.
CHECKING THE CURRENT MEMORY
SETTINGS
If you hold down
opens and the set values for receive tone (
tone ( tt on / off
offset ( rPt ), and frequency step (
Release (
MO REV

SETTING THE FREQUENCY STEP

To change the frequency increment used during scanning and
stepping to a frequency, use the Main Menu to access the CS op-
tion setting (see "Using the HTX-200's Menus" on Page 16). Then
repeatedly press
can change the frequency step to 5 kHz, 10 kHz, 12.5 kHz, 15
kHz, 20 kHz, 25 kHz, 50 kHz, or 1 MHz. (The example shown
here is 25 kHz.)
FUNC
( ) for longer than 1 second, the squelch
MO REV
), scan skip condition (
) to turn on the squelch again.
or until you reach the desired setting. You
+ (
FUNC BEEP)
+ (
BEEP
rT on
SCSP
CS ) appear.
. disappears.
) again.
/ ), transmit
off
)(if any), repeater
39