SETTING THE REPEATER OFFSET
The HTX-200's default repeater offset is 600 kHz, which appears
(MHz ). Follow these steps to change the offset.
Note: This setting only affects the VFO mode. If you saved a fre-
quency offset in a memory, that setting is not affected.
1. With power off, hold down
2. Hold down
current offset appear.
3. Repeatedly press
You can set an offset between 0 and 8 MHz in 100kHz
OPERATION ON AND OFF
To turn on duplex (repeater use) operation for the VFO mode,
ue is not
appears above the displayed frequency. Press
again to turn it off.
and repeatedly press
to store the setting and exit the menu.
). Provided the current repeater offset val-
, the current offset indicator (
and turn on the HTX-200,
appears if no offset is currently
until the desired offset appears.