Drill Piping Hole; Installation Of Drain Hose - Electrolux EXI09HD1W Installation Manual

Step 2: Drill Piping Hole
1 Determine hole positions according to the
in the wall at a slight downward slant to the
outdoor side.
Piping hole
2 The inclination must be between 5 - 10mm in
order to ensure a good drain of condensed
water generated by the indoor unit.
Indoor
Wall pipe
5-10mm
3 Insert the wall pipe into the hole to prevent
and wiring from being damaged when passing
through the whole.
4 Always use a wall hole conduit when drilling
metal grids, metal plates or the like.
5 For cooling capacity over 4500W models,
remove and dispose the two polystyrene lateral
rear supports from the indoor unit before the
installation.
10
Model
Cooling capacity <6000W
Cooling capacity >6000W
Outdoor
Seal putty
Ø55
or Ø70
Wall
Remove both supports
Step 3: Installation of Drain Hose
1 Connect the drain hose to the outlet pipe of the
indoor unit. Bind the joint with vinyl tape.
Outlet pipe of
indoor unit
Vinyl tape
2 Put the drain hose into insulating pipe.
Outlet pipe of
indoor unit
Vinyl tape Insulating pipe
3 Wrap the insulating pipe with wide vinyl tape
to prevent the shift of insulating pipe. Slant
the drain hose downward slightly for smooth
drainage of condensing water.
Vinyl tape
Outlet pipe of
indoor unit
Connected
Outlet pipe of
indoor unit
Drain hose
Drain hose (narrow)
Insulating pipe