TM
XMODS
Custom RC
Metal Bearing Upgrade
Upgrade from standard plastic bushings to metal ball bearings for reduced friction,
greater precision, and better handling. Before installing, turn off your vehicle and
controller and then detach the car body.
Preparing for Your Metal Bearing Upgrade
1
Use the lug wrench supplied in your XMODS
to detach the front lug nuts and wheels.
Tips
•
Carefully count and set aside screws while disassembling so you can properly reassemble your car later.
•
Bearings can be fitted in place in either direction.
•
Be careful that the lead solder joints inside the car do not become detached.
•
You may find it useful to remove the antenna from the chassis.
Screw
Location
Rear Upper
Deck (short)
Quantity
4
Upgrading the Rear Section to Metal Bearings
1
Remove six screws (2 long, 4 short) from the rear upper
deck to detach it.
2 long screws
3
Remove two screws from the rear lower deck.
www
www
www.xmodsRC.com
www
www
.xmodsRC.com
.xmodsRC.com
.xmodsRC.com
.xmodsRC.com
60-8512
TM
Starter Kit
Screw Guide (Rear of Car)
Rear Upper
Motor
Deck (long)
Holders
2
4
4 short screws
Tip:
When reassembling, align
the center shaft's D-cut
with the D-cut in the gear.
Tip:
For best performance and fit,
before installing bearings,
lightly brush each shaft with
fine sandpaper to remove
burrs and blemishes.
2
Loosen and remove each damper screw and detach
the right and left front and rear dampers.
Rear Lower
Rear Support
Deck
Arms
2
4
2
Diconnect the motor connector. Remove two
screws from each motor holder and remove the
motor holders and motor.
Motor Holders
4
Remove the rear lower deck from the chassis.
Center Shaft
Rear Lower
Rear Center
Deck
Shaft Holder
4
2
Motor
1 1 1 1 1
Center Shaft Holder