NEC N8103-106 User Manual page 61

Additional dac battery
Table of Contents

Advertisement

39
11.
Connect the cable between the disk array controller and the system to recover
original state
12.
Put Setup Date Label to the place that you notice easily such as system case.
13.
Install the side cover on the server. Connect power cord to the receptacles to
recover the original state and power on the system.
14.
To confirm whether the disk array controller is recognized from system after OS
started. In detail, refer to [2-2. Checking by Utility].
WebPAM PRO may not able to recognize the battery pack if it is charged only at the
minimum level (or uncharged). If this occurs, charge the battery pack for six hours or
longer. Then reboot the server and try to recognize the battery pack again by using
WebPAM PRO.
Notice
The battery pack is recyclable. To inquire about it , contact your service
representative or bring it to the nearest recycle agent.
Tips
HDD LED
Connector
Connect the
black cable
to this pin.
1
2
Connect the red cable to this
pin. (This is not used for a
single-line LED cable.)
LED Cable
SAS Cable

Advertisement

Table of Contents
loading

Table of Contents