Table of Contents
Advertisement
Channel list version
Check the current version of the channel list...
1 - Press , select General settings > Channel List
Copy and press OK.
2 - Select Current version, then press OK.
3 - Press (left) repeatedly if necessary, to close
the menu.
Upload a channel list
To TVs that are not installed
Depending on whether your TV is already installed or
not, you must use a different method to upload a
channel list.
To a TV that is not yet installed
1 - Plug in the power plug to start the installation and
select language and country. You can skip the
channel search. Finish the installation.
2 - Plug in the USB flash drive that holds the channel
list of the other TV.
3 - To start the channel list upload, press ,
select General settings and press OK.
4 - Select Channel List Copy > Copy to TV and
press OK. Enter your PIN code if necessary.
5 - The TV notifies you if the channel list is copied to
the TV successfully. Unplug the USB flash drive.
To installed TVs
Depending on whether your TV is already installed or
not, you must use a different method to upload a
channel list.
To an already installed TV
1 - Verify the country setting of the TV. (To verify this
setting, see chapter Reinstall All Channels. Start this
procedure until you reach the country setting.
Press BACK to cancel the installation.)
If the country is correct continue with step 2.
If the country is not correct, you will need to start a
reinstallation. See chapter Reinstall All Channels and
start the installation. Select the correct country and
skip the channels search. Finish the installation. When
done, continue with step 2.
2 - Plug in the USB flash drive that holds the channel
list of the other TV.
3 - To start the channel list upload, press ,
select General settings and press OK.
4 - Select Channel List Copy > Copy to TV and
press OK. Enter your PIN code if necessary.
5 - The TV notifies you if the channel list is copied to
the TV successfully. Unplug the USB flash drive.
21.3
Digital Channel Installation
If you know the channel frequency of the channels
you want to install, you can search and store digital
channels one by one. For best results, contact the
service provider.
1 - Press .
2 - Enter the PIN code if asked.
3 - Select Antenna/cable installation and press OK.
4 - Select Digital: Reception Test > Search and
press OK.
5 - Press the numbered buttons to enter the channel
frequency.
6 - Select Search and press OK.
7 - When the channel is found, select Done and
press OK.
21.4
Service Navigation
To switch off...
1 - Press , select Antenna/cable installation and
press OK.
2 - Enter your PIN code if necessary.
3 - Select Service navigation and press OK.
4 - Select Off and press OK.
5 - Press BACK to close the menu.
58
Advertisement
Table of Contents
