Software Upgrade - Philips DVP3136/94 Service Manual

Software upgrade

Preparation to upgrade software
1) Start the CD Burning software and create a new CD
project (Data Disc) with the following setting:
Label: DVP3XXX (No need the label name)
Note: It is required capital letter for the File System
name, and it no need have the File name during
start the CD burning software for Zoran project.
2) Burn the data onto a blank CDR
A. Procedure for software upgrade:
1) Power on the set and insert the prepared Upgrade
CDR.
2) The set will starts reading disc & response with the
following display TV screen:
Loading
Firmware Upgrade Erase and program.
Start
Select Start to start upgrade.
3) Press <OK> button to confirm, then screen will display :
Firmware Upgrade Programming, Please Wait...
Do not Switch the Player Off !
4) The upgraded disc will automatically out when files
coping complete, then take out the disc.
5) About 1 minute later, the tray will automatically close
when upgrading complete.
Cancel
3-1
B. Read out the software versions to confirm upgrading
1) Power on e set and Open the tray door.
2) Press <9><6><6>button to check the software
information.
The software version and other information are display
on the TV screen as follows:
BE Version: DVP3XXXXX_XX.XX
FE Version: DCX.XXXXXX.XX.XX
DSP Version: DSP.XX
Region Code: X
Caution: The set must not be power off during
upgrading, Otherwise the Main board will be
damaged entirely.