Handlebar Switches - Yamaha X MAX CZD300-A Owner's Manual

Handlebar switches

Left
1
2
3
1. Dimmer/Pass switch " /
2. Turn signal switch " / "
3. Horn switch " "
Right
1. Stop/Run/Start switch " /
2. Hazard switch " "
3. "TRIP/INFO" switch
EAU1234M
Dimmer/Pass switch "
Set this switch to "
beam and to "
To flash the high beam, push the pass
side "PASS" of the switch while the
headlights are on low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
/PASS"
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
1
Press this switch to sound the horn.
Stop/Run/Start switch "
To crank the engine with the starter,
2
set this switch to "
3
the switch down towards "
page 7-2 for starting instructions prior
/ "
to starting the engine.
Instrument and control functions
EAU54201
/ /PASS"
" for the high
" for the low beam.
EAU12461
/ "
". To signal a left-hand
". When
EAU12501
"
EAU54212
/ / "
", and then push
". See
5-11
Set this switch to " " to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch " "
With the main switch in the "ON" posi-
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
"TRIP/INFO" switch
This switch is used to make setting and
display changes in the multi-function
meter unit. See page 5-3 for more in-
formation.
EAU79500
5
ECA10062
EAU78491