Download Print this page
Radio Shack 16-3009 User Manual

Radio Shack 16-3009 User Manual

2.3” lcd tv

Advertisement

Quick Links

2.3" LCD TV
16-3009
Power
BATTERY POWER
Your TV requires four AA batteries (not supplied).
You may purchase alkaline batteries from your local
RadioShack store.
1. Slide off the battery compartment cover.
2. Insert the batteries into the compartment
(three above and one below) as indicated by the
polarity symbols (+ and –) marked inside.
3. Replace the cover.
Notes:
• The TV can operate for about 4 hours with alkaline batteries. When the sound level
lowers or the picture becomes unstable, replace the batteries.
• The TV's internal batteries automatically disconnect when you connect an adapter.
AC POWER
You can power the TV using a regulated 6V AC adapter of at
least 500 mA, and a size B Adaptaplug™ adapter (neither
supplied). Both are available at your local RadioShack store.
Set the adapter's voltage switch to 6V. Insert the Adaptaplug into
the adapter's cord, aligning + with TIP. Plug the Adaptaplug's
barrel plug into the TV's
jack. Then plug the other end
DC IN 6V
of the AC adapter cord into a standard AC outlet.
Note: The adapter might become warm after extended periods
of use.
USING VEHICLE BATTERY POWER
You can power the TV from a vehicle's 12V power source (such as a cigarette-lighter
socket) using a 6V, 500-mA DC adapter and a size B Adaptaplug™ adapter (neither
supplied). Use an optional DC adapter to power the TV from a vehicle's cigarette-lighter
socket if the vehicle has a 12V DC, negative ground electrical system.
Set the adapter's voltage switch to 6V. Insert the Adaptaplug into the adapter's cord,
aligning + with TIP. Plug the Adaptaplug's barrel plug into the TV's
the vehicle's cigarette lighter and plug the large end of the DC adapter cord into the
cigarette-lighter socket.
Note: If the TV does not operate properly when you use DC power, be sure the cigarette-
lighter socket is clean and that the adapter's plug is properly connected to the socket.
EXT. ANT. Jack - Lets you
connect an external antenna for
optimum reception in weak
signal areas.

Using Your TV

1. Extend the rod antenna and slide
in the selected band.
Built-in Rod Antenna
2. Press
TUNING
below the screen.
3. To adjust the volume, rotate
4. To adjust the picture to the desired brightness, rotate
UHF/VHF/OFF
changes with the screen's angle.
BACKLIGHT
In low temperatures, the TV screen takes a few seconds to light, or it might be slightly red
DC IN 6V Jack
in color. This is not a malfunction. Normal operation resumes after a few seconds.
USING AN EARPHONE
For private listening, you can connect an optional earphone with a
jack. This automatically mutes the built-in speaker.
Cautions:
• Set
VOLUME
• Do not use an earphone when operating a vehicle or riding a bicycle. This can cause a traffic hazard and can be illegal in
some areas.
jack. Unplug
DC IN 6V
Optional Accessories
6V Vehicle DC Adapter
EAR Jack - Lets you enjoy
private listening with an optional
earphone.
Flat LCD - makes the TV more
compact and uses less power
than a standard picture tube.
Volume - Turn the dial to adjust
the volume level.
Bright - Turn dial to adjust the
brightness level.
Ý
Þ -
Tuning
/
Turn dial to adjust
the picture to the desired television
channel.
Use the stand to lean the TV
against flat surfaces.
to
or
UHF/VHF/OFF
VHF
UHF
to tune to a different channel. The tuning line on the screen aligns with the selected channel number
located on the right side of the TV.
VOLUME
BRIGHT
to the lowest setting before you begin listening. Then adjust the volume to a comfortable level.
Earphones
Size B Adaptaplug
External Antenna
If you are in an area with weak TV signals, or
inside a metal or concrete building, you might
need an external antenna to improve reception.
Connect the antenna to the EXT. ANT. jack. If
your antenna wire is 75-ohm coaxial cable, use
an F-to-mini plug adapter to complete the
connection. If you have 300-ohm wire, use a
300-to-75 ohm mini plug adapter. Both are
available at your local RadioShack store.
EXT. ANT. Jack
. The TV starts scanning and stops at the next active channel
located on the right side of the TV. The brightness also
1
/
-inch plug to the
EAR
8
EAR Jack
6V AC to DC Adapter
Alkaline Batteries

Advertisement

loading

Summary of Contents for Radio Shack 16-3009

  • Page 1: Using Your Tv

    2.3” LCD TV 16-3009 Power BATTERY POWER Your TV requires four AA batteries (not supplied). You may purchase alkaline batteries from your local RadioShack store. 1. Slide off the battery compartment cover. 2. Insert the batteries into the compartment (three above and one below) as indicated by the polarity symbols (+ and –) marked inside.
  • Page 2: Specifications

    This warranty gives you specific legal rights, and you may also have other rights which vary from state to state RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102 12/99 ©2004 RadioShack Corporation. 16-3009 All Rights Reserved. Printed in China RadioShack and RadioShack.com are trademarks 03A04 used by RadioShack Corporation.