Advertisement
Quick Links
63-984.fm Page 1 Wednesday, September 8, 1999 4:42 PM
Wireless Intercom Door Chime
Your RadioShack Wireless Intercom
Door Chime operates as a two-tone
doorbell and an intercom. The chime
is simple to install because it requires
no wiring. Your chime's two channel
switch and digital coding prevent other
transmitters or radio devices from
sounding the chime. To conserve
power, both the receiver and transmit-
ter automatically turn off 30 seconds
after you stop using them.
The chime includes these features:
Separate Buttons for Bell and Inter-
com — let your callers first announce
their arrival and then communicate us-
ing the intercom.
Receiver Volume Control — lets you
adjust the volume to a comfortable lev-
el.
2-Channel Transmitter and Receiv-
er with Digital Code Selection — as-
sure interference-free communication.
50-Foot Usable Operation Distance
— means you can install the transmit-
ter and receiver virtually anywhere in
your home or business.
RadioShack is a registered trademark used by Tandy Corporation.
Indicators — light so you can easily
confirm the chime's operation.
WARNING:
shock hazard, do not expose this product to rain
or moisture.
CAUTION:
ELECTRIC SHOCK, DO NOT REMOVE
COVER OR BACK. NO USER-SERVICE-
ABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED PERSONNEL.
!
©
1999 Tandy Corporation.
All Rights Reserved.
Cat. No. 63-984
To reduce the risk of fire or
CAUTION
!
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
TO REDUCE THE RISK OF
This symbol is intended to alert
you to the presence of uninsu-
lated dangerous voltage within
the product's enclosure that might
be of sufficient magnitude to con-
stitute a risk of electric shock. Do
not open the product's case.
This symbol is intended to inform
you that important operating and
maintenance
instructions
included in the literature accom-
panying this product.
are
Advertisement
Related Manuals for Radio Shack 63-984
Summary of Contents for Radio Shack 63-984
- Page 1 63-984.fm Page 1 Wednesday, September 8, 1999 4:42 PM Wireless Intercom Door Chime Your RadioShack Wireless Intercom Door Chime operates as a two-tone doorbell and an intercom. The chime is simple to install because it requires no wiring. Your chime's two channel...
- Page 2 63-984.fm Page 2 Wednesday, September 8, 1999 4:42 PM PREPARATION Setting the Channel and Code transmitter receiver equipped with two selectable operation channels and two selectable digital codes, to ensure positive operation and prevent interference from similar prod- ucts nearby. Select the same channel and code number for both the transmit- ter and the receiver.
-
Page 3: Mounting The Transmitter
63-984.fm Page 3 Wednesday, September 8, 1999 4:42 PM 2. Place the batteries into the battery compartment as indicated by the polarity symbols (+ and –) marked inside. 3. Be sure the rubber seal around the battery compartment is properly positioned, then replace the cover and tighten the screw. -
Page 4: Mounting The Receiver
63-984.fm Page 4 Wednesday, September 8, 1999 4:42 PM low). Then insert an anchor into each hole. Inch Diameter Hole 50mm 85mm 2. Align the metal mounting bracket with the holes you just drilled and drive a screw through the bracket into each hole. -
Page 5: Operation
63-984.fm Page 5 Wednesday, September 8, 1999 4:42 PM 3. Route the AC power cord beneath the tabs on either side of the chan- nel on the back of the receiver 4. Align the receiver's keyhole slots with the screw heads and slide the receiver down to secure it. -
Page 6: Specifications
63-984.fm Page 6 Wednesday, September 8, 1999 4:42 PM Changes or modifications to this product not expressly approved by RadioShack, or operation of this product in any way other than as detailed by this Owner’s Manual, could void your authority to op- erate the product.