Software Upgrade - Philips DVP1120 Service Manual

Software upgrade

A. Preparation to upgrade software
1) Start the CD Burning software and create a new CD project (Data Disc) with the following setting:
Label: DVPXXXX (No need the label name)
File Name: DVPXXXX_XX.BIN
Power on the set and open the tray, then press <5><5>
to check the File Name.
Note: It is required capital letter for the File System name.
2) Burn the data onto a blank CDR
B. Procedure for software upgrade:
1) Power up the set and insert the prepared Upgrade CDR.
2) The set will starts reading disc & response with the following display TV screen:
Upgrade File DETECTED
Upgrade?
Press Play TO START.
3) Press <OK> button to confirm, then screen will display :
Files coping...
UPGRADING...
4) The upgraded disc will automatically out when files coping complete, then take out the disc.
5) About 1 minute later, the trace will automatically close when upgrading complete.
C. Read out the software versions to confirm upgrading
1) Power up the set and press <Setup> button on the remote control.
2) Press <1><3><7><9> button.
The software version and other information are display on the TV screen as follows:
Version XX.XX.XX.XX (main version)
SUB-VER XX.XX.XX.XX (software version of
8032 XX.XX.XX.XX
Servo XX.XX.XX.XX (software version of Servo)
RISC XX.XX.XX.XX
DSP XX.XX.XX.XX
Region Code XX
Caution: The set must not be power off during
upgrading, in that case the decoder board will
be damaged entirely.
application software)
3-1