Depth Gauge - Makita HR4003C Instruction Manual

Clean the bit shank and apply bit grease before installing the bit.
1
2
1. Bit 2. Release cover
Insert the bit into the tool. Turn the bit and push it in until it engages.
release cover down a couple of times. Then insert the
bit again. Turn the bit and push it in until it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
1
2
1. Bit 2. Release cover
To remove the bit, pull the release cover down all the
way and pull the bit out.
Bit angle (when chipping, scaling or
demolishing)
2
1. Change lever 2.
The bit can be secured at 24 different angles. To
change the bit angle, rotate the change lever so that
the pointer points to the
desired angle.
1
symbol. Turn the bit to the
1. Change lever 2.
Rotate the change lever so that the pointer points to
the symbol. Then make sure that the bit is securely
held in place by turning it slightly.

Depth gauge

1
1. Depth gauge 2. Lock button
The depth gauge is convenient for drilling holes of
uniform depth.
gauge into the hex hole.
Make sure the toothed side of the depth gauge faces
the marking.
the lock button to lock the depth gauge.
8 ENGLISH
1
2
2