Makita HR4003C Instruction Manual page 6

Hide thumbs Also See for HR4003C:
Table of Contents

Advertisement

Selecting the action mode
CAUTION:
running. The tool will be damaged.
anism, be sure that the change lever is always
positively located in one of the action mode
positions.
Hammer drilling mode
1
2
1. Change lever 2.
For drilling in concrete, masonry, etc., rotate the change
lever to the
symbol. Use a tungsten-carbide tipped
bit.
Hammering mode (Switch trigger
mode)
1
2
1. Change lever 2.
For chipping, scaling or demolition operations, rotate
the change lever to the
chisel, scaling chisel, etc.
symbol. Use a bull point, cold
Hammering mode (Switch button
mode)
2
-
1
1. Change lever 2.
For continuous chipping, scaling or demolition opera-
tions, rotate the change lever to the
1. Switch button
Use a bull point, cold chisel, scaling chisel, etc.
NOTE:
switch trigger does not work but only the switch
button works.
Torque limiter
The torque limiter actuates when torque reaches a cer-
tain level. The motor disengages from the output shaft.
CAUTION:
off the tool immediately. This helps to prevent
premature wear of the tool.
6 ENGLISH
symbol.
1
symbol mode, the

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hr4013cHr5202cHr5212c

Table of Contents