Firmware Revisions - GE L90 Instruction Manual

PRODUCT INFORMATION
The order code, serial number, Ethernet MAC address, date and time of manufacture, and operating time are shown here.
The rear panel on the device contains similar information.
ETHERNET MAC ADDRESS
networks. The MAC address displays for port 1. The MAC address for port 2 is one higher. The MAC address for port 3 is one
higher than port 2. In redundant mode, the MAC addresses for ports 2 and 3 are the same as port 2.

6.6.2 Firmware revisions

ACTUAL VALUES  PRODUCT INFO  FIRMWARE REVISIONS
 FIRMWARE REVISIONS

6
The shown data is illustrative only. A modification file number of 0 indicates that, currently, no modifications have been
installed.
6-34
OPERATING TIME:

0:00:00
PMU FEATURE ACTIVE:

No
CT/ VT ADVANCED DIAG

ACTIVE: No
LAST SETTING CHANGE:

1970/01/01 23:11:19
— UR devices with firmware 7.0x and above have three Ethernet ports that can be used on three
L90 Relay

REVISION: 7.4x
MODIFICATION FILE

NUMBER: 0
BOOT PROGRAM

REVISION: 7.01
FRONT PANEL PROGRAM

REVISION: 2.01
COMPILE DATE:

2016/09/15 04:55:16
BOOT DATE:

2013/09/15 16:41:32
FPGA PROGRAM

REVISION: 02.02
FPGA DATE:

2016/09/15 16:41:32
Range: operating time in HH:MM:SS
Range: Yes, No
Range: Yes, No
Range: YYYY/MM/DD HH:MM:SS
Range: 0.00 to 655.35
Revision number of the application firmware.
Range: 0 to 65535 (ID of the MOD FILE)
Value is 0 for each standard firmware release.
Range: 0.00 to 655.35
Revision number of the boot program firmware.
Range: 0.00 to 655.35
Revision number of faceplate program firmware.
Range: YYYY/MM/DD HH:MM:SS
Date and time when product firmware was built.
Range: YYYY/MM/DD HH:MM:SS
Date and time when the boot program was built.
Range: 0.00 to 655.35
Revision number for FPGA.
Range: YYYY/MM/DD HH:MM:SS
Date and time when the FPGA was built.
L90 LINE CURRENT DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
CHAPTER 6: ACTUAL VALUES