Dell S5000 Deployment/Configuration Manual page 26

Dell Networking S5000: Deployment of a Converged Infrastructure with FCoE
In Figure 24 below, you can see the output of the 'switchshow' command on the fabric A FC switch.
Notice that the port connected to the Dell S5000 switch (port 4) now states "F-Port 1 N Port + 1 NPIV
public" similar to those connected to the Compellent array which is in virtual port mode. As the Dell
S5000 switch is acting as a NPIV Proxy Gateway, it will always have only one N_Port on this link, and
the remaining connections through the link will cause the NPIV count to increase.
Figure 24: Output of the 'switchshow' command on the fabric A FC switch
The 'nsshow' command output below shows that both the Dell QLogic CNA and Dell S5000 switch
are logged into fabric A. Note here that the QLogic adapter WWPN is '20:01:00:0e:1e:0f:2d:8e' and the
Dell S5000 WWPN is '20:00:5c:f9:dd:ef:25:c0'. The four storage WWPNs are unchanged.
26 Deployment of a Converged Infrastructure with FCoE
Deployment/Configuration Guide