Siemens SIMATIC ET 200AL Manual page 20

Parameters/address space
4.1 Parameters
The following table shows the port parameters for the communication module
CM 4xIO-Link 4xM12 with firmware version V1.1.
Table 4- 2
Parameters
Port configuration
Operating mode
Length of input data
(without PQI)
Length of output data
Vendor ID**
Device ID**
Testing accuracy / data
storage**
* Take care not to exceed the maximum possible length of the input or output data for all ports.
Example:
You have selected the 32I/32O configuration. You have assigned the first port 16 bytes of input
data.
You can still assign a total of 16 bytes of input data for the remaining three ports.
** Only in effect when "IO-Link manual" port mode is used.
20
Port parameters
Range of values
IO-Link autostart
•
IO-Link manual
•
DI
•
DQ
•
Disabled
•
Depending on the total length of
the module*
Depending on the total length of
the module*
Vendor ID of the connected
IO-Link device
Device ID of the connected
IO-Link device
Same type (V1.0) without
•
Backup&Restore
Type compatible (V1.1)
•
without Backup&Restore
Type compatible (V1.1) with
•
Backup&Restore
Type compatible (V1.1) with
•
Restore
Communication module CM 4xIO-Link 4xM12(6ES7147-5JD00-0BA0)
Default
IO-Link autostart
Depending on the total length of
the module*
Depending on the total length of
the module*
0
0
Type compatible (V1.1) with
Backup&Restore
Manual, 10/2017, A5E32352322-AE