2. Installing Web PDI
Configuring indoor units information on ACCS
If previous installation step is done, next step should be configuration of indoor unit information. This
step should be performed on ACCS program. The way of configuration is described as follows :
1.
Execute the Internet Explorer at the PC connected to tye Web PDI via the Internet or the internal network.
And then, enter the IP address set at the Web PDI into the address window, and press [Enter] key.
Note: Web PDI access IP
If you don't know the access IP of the Web PDI, check the Web PDI setup IP by referring to
Chapter 2. Configuring the Web PDI network – Checking the network environment.
2-22
Web PDI
Enter Web PDI access IP