Download Print this page
Radio Shack 63-1514 User Manual
Radio Shack 63-1514 User Manual

Radio Shack 63-1514 User Manual

Arm cuff blood pressure monitor

Advertisement

Quick Links

Arm Cuff Blood
Pressure Monitor
63-1514
Step One
Installing Batteries
1. Press the tab to lift up the battery compartment cover.
2. Insert four AA batteries (not supplied) into the compartment as
indicated by the polarity symbols (+ and –) marked inside.
3. Pull down the cover then press the cover down to snap it in
place.
!
When the display dims or the batteries weaken,
display. Replace the batteries.
Or
Using an AC Adapter
You can also power the blood pressure monitor using a 6V DC, 1A
AC adapter. To connect an AC adapter to the blood pressure moni-
tor, attach a size M Adaptaplug
to the adapter with its tip set to
TM
positive. Insert the adapter's barrel plug into the monitor's DC 6V
jack. Then plug the adapter into a standard AC outlet.
Step Two
Setting the Date and Time
1. Press
. The month digit flashes.
MODE
2. Repeatedly press (or hold down)
the correct month.
3. Repeat Steps 1 and 2 to set the date, hour,
and minute.
4. Press
to complete setting.
MODE
What's Included
appears on the
Auto Inflatable Arm Cuff
Monitor
Carry Pouch
Optional Accessories
Body Fat Analyzer
Environizer
Rechargeable Batteries
Battery Charger
Step Three
Attaching the Arm Cuff
1. Roll up your sleeve to prevent constricting
circulation to your arm.
2. Insert the plug
at the end of
the tube into
the jack on the
left side of the
monitor.
3. Sit upright on
the chair, and
with your palm
face up, thread
the cuff through your arm until it reaches
your biceps, just above your elbow.
4. Adjust the cuff so the inflation tube is on the
top of your arm as shown. Leave the cuff's
bottom edge about 0.8 to 1.2 inches (2 – 3
to set
SET
cm) above the crease of your elbow.
Step Four
Measuring Blood Pressure
1. Press
START/STOP
160 mmHg, or the necessary inflation level. The systolic rate decreases gradually, G appears,
and
flashes at the same rate as your heartbeat.
2. Once your blood pressure is detected, the monitor deflates slowly. The blood pressure reading
and pulse rate appear. The air pressure in the arm cuff releases.
3. To stop the measurement at any time, press
#
appears briefly when:
You do not wrap or position the cuff around your arm correctly.
You talk or move the body during measurement.
You have incorrect posture.
The batteries become weak and
5. Fasten the cuff snugly, leaving at least a
finger's room in between the cuff and your
arm.
6. Place your arm on the table so the cuff is at
the same height as your heart. Be sure the
inflation tube lines up with your arm
. All display segments appear briefly and the monitor automatically inflates to
.
START/STOP
!
flashes.

Advertisement

loading

Summary of Contents for Radio Shack 63-1514

  • Page 1 Replace the batteries. Using an AC Adapter You can also power the blood pressure monitor using a 6V DC, 1A AC adapter. To connect an AC adapter to the blood pressure moni- tor, attach a size M Adaptaplug to the adapter with its tip set to positive.
  • Page 2: Specifications

    Care Keep the blood pressure monitor dry; if it gets wet, wipe it dry immediately. Use and store the blood pressure monitor only in normal temperature environments. Handle the blood pressure monitor carefully; do not drop it. Keep the blood pressure monitor away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new.