Pwm Mode - Hitachi H8/3022 Hardware Manual

8.4.4 PWM Mode

In PWM mode GRA and GRB are paired and a PWM waveform is output from the TIOCA pin.
GRA specifies the time at which the PWM output changes to 1. GRB specifies the time at which
the PWM output changes to 0. If either GRA or GRB is selected as the counter clear source, a
PWM waveform with a duty cycle from 0% to 100% is output at the TIOCA pin. PWM mode can
be selected in all channels (0 to 4).
Table 8-4 summarizes the PWM output pins and corresponding registers. If the same value is set
in GRA and GRB, the output does not change when compare match occurs.
Table 8-4 PWM Output Pins and Registers
Channel
0
1
2
3
4
234
Output Pin
TIOCA
0
TIOCA
1
TIOCA
2
TIOCA
3
TIOCA
4
1 Output
GRA0
GRA1
GRA2
GRA3
GRA4
0 Output
GRB0
GRB1
GRB2
GRB3
GRB4